62
Setting the alarm clock
Gigaset S810-S810A / Grossbritannien / A31008-M2306-L101-1-7619 / registr_sett.fm / 18.03.2011
V
e
rsion 4.1, 21
.11.2007
Setting the alarm clock
Prerequisite:
already been set (
Activating/deactivating and
setting the alarm clock
v
¢
á
¢
Alarm Clock
¤
You can enter data in the following fields:
Activation:
Select
On
or
Off
.
Time:
Enter the wake-up time in 4-digit format.
Occurrence:
Select
Daily
or
Monday-Friday
.
Volume:
Set the volume (1–6).
Signal:
Select melody.
§Save§
Press the display key.
In idle status, the
¼
icon and wake-up time
are displayed.
A wake-up call is signalled on the display
and with the selected ringtone (
The wake-up call sounds for 60 seconds. If
no key is pressed, the wake-up call is
repeated twice at five minute intervals and
then switched off.
While the wake-up call sounds,
you can
permanently change the volume by press-
ing the side keys
ø
(louder) or
÷
(quieter).
During a call, the wake-up call is only sig-
nalled by a short tone.
Deactivating the wake-up call/
repeating after a pause (snooze
mode)
Prerequisite
: A wake-up call is sounding.
§Off§
Press the display key. The wake-
up call is deactivated.
or
§Snooze§
Press the display key or any key.
The wake-up call is deactivated
and then repeated after 5 min-
utes. After the second repetition
the wake-up call is deactivated
completely.
Using multiple handsets
Registering handsets
You can register up to six handsets to your
base.
A Gigaset S810H handset can be registered
on up to four bases.
Manually registering a
Gigaset S810H to a Gigaset S810/
S810A
You must activate manual registration of the
handset on both the handset (1) and the
base (2).
When the registration process has com-
pleted successfully, the handset returns to
idle status. The handset's internal number is
shown in the display e.g.,
INT 1
. If not, repeat
the procedure. .
1) On the handset
The handset is not registered to a base.
§Register§
Press the display key.
The handset is already registered to a base:
v
¢
Ï
¢
Registration
¢
Register Handset
If the handset is already registered to four
bases:
s
Select base, e.g.,
Base 3
and
press
§OK§
.
~
If required, enter the system
PIN for the base and press
§OK§
.
A message appears stating that the hand-
set is searching for a base that is ready for
registration.
