45
Using several handsets
Gigaset S670/S675 / IM-MEA En / A31008-M1904-A601-1-3T19 / registr_sett.fm / 13.8.07
Ve
rs
ion 4,
16
.09.
2005
Changing the name of a handset
The names "INT 1", "INT 2" etc. are
assigned automatically at registration.
You can change these names. The name
must be no more than 10 characters. The
changed name is displayed in every hand-
set's list.
u
Open list of handsets. Your
own handset is indicated by
<
.
s
Select handset.
§Edit§
Press the display key.
~
Enter name.
§Save§
Press the display key.
Changing a handset's internal
number
A handset is
automatically
assigned the
lowest free number on registration. If all
slots are occupied, number 6 is overwrit-
ten if this handset is in idle status. You can
change the internal number of all regis-
tered handsets (1–6).
u
Open list of handsets. Your
own handset is indicated by
<
.
Options
Open menu.
Edit H/Set No.
Select and press
§OK§
. The list of
handsets is displayed.
s
The current number flashes.
Select a handset.
~
Enter the new internal number
(1–6). The handset's old
number is overwritten.
§Save§
Press the display key to save
the input.
a
Press
and
hold
(idle status).
You will hear the error tone (descending
tone sequence) if you assign an internal
number twice.
¤
Repeat the procedure with a free
number.
Using a handset as a
room monitor
If the room monitor is activated, a previ-
ously saved destination number is called
as soon as a set noise level is reached. You
can save an internal or external number in
your handset as the destination number.
The room monitor call to an external
number stops after around 90 seconds.
The room monitor call to an internal
number (handset) stops after approx.
3 minutes (depending on the base sta-
tion). When the room monitor is activated,
all keys are locked except the end call key.
The handset's speaker is muted.
When the room monitor is activated,
incoming calls to the handset are indi-
cated
without a ringer tone
and are only
shown on the screen. The display and key-
pad are not illuminated and advisory
tones are also turned off.
If you accept an incoming call, the room
monitor mode is suspended for the dura-
tion of the call, but the function
remains
activated.
The room monitor mode is retained if you
turn the handset off and on again.
Caution!
–
You should always check the operation
of the room monitor before use. For
example, test its sensitivity. Check the
connection if you are diverting the room
monitor to an outside number.
– When the function is activated the hand-
set's operating time is severely reduced.
If necessary, place the handset in the
charging cradle. This ensures that the
batteries do not run down.
– Ideally the handset should be positioned 1
to 2 metres away from the baby. The micro-
phone must be directed towards the baby.
– The connection to which the room monitor
is diverted must not be blocked by an acti-
vated answer machine.
