76
Using several handsets
Gigaset S450 IP LBA / IM-Nord_en / A31008-M1713-R221-2-7619 / T-NetBox_SAG-registration.fm / 28.3.07
Ve
rs
ion 4,
16
.09.
2005
Using a handset as a room
monitor
If the room monitor is activated, a previ-
ously stored destination number is called
as soon as a set noise level is reached in
the room.
You can store an internal or external
number in your handset as the destination
number.
The room monitor call to an external
number stops after around 90 seconds.
The room monitor call to an internal
number (handset) stops after around
3 minutes (depending on the base
station). During use as a room monitor,
all keys are barred except for the end call
key
a
. The speaker of the handset is
muted. The end call key can only be used
to deactivate the handset.
When the room monitor is activated,
incoming calls to the handset are indi-
cated
without a ringer tone
and are only
shown on the screen. The display and
keypad are not illuminated and advisory
tones are also turned off.
If you accept an incoming call, the room
monitor mode is suspended for the dura-
tion of the call, but the function
remains
activated.
If you switch off the handset, the room
monitor mode is deactivated. You must
reactivate the function when you switch
the handset back on.
Activating the room monitor and
entering the number to be called
v
¢
í
Add. Features
¢
Room Monitor
¤
Change multiple line input:
Room M.:
Select
On
to activate.
Call to:
Press the display key
§Edit§
and enter des-
tination number.
External number:
Select number from
the directory or enter directly. Only
the
last 4 characters
are displayed.
Internal number:
Delete any stored
external number.
§INT§
s
(select hand-
set or
Call All
, if all registered handsets
are to be called)
§OK§
.
Store number with
Save
.
Level:
Set noise level sensitivity (
Low
or
High
).
¤
Save changes (page 112).
The function is now activated. With
v
,
you can move directly to settings.
Caution!
–
You should always check the operation
of the room monitor before use. For
example, test its sensitivity. Check the
connection if you are diverting the room
monitor to an outside number.
– When the function is switched on the hand-
set's operating time is severely reduced. If
necessary, place the handset on the base
station. This ensures that the batteries do
not run down.
– Ideally the handset should be positioned 1
to 2 metres away from the baby. The micro-
phone must be directed towards the baby.
– The connection to which the room monitor
is diverted must not be blocked by an acti-
vated answer machine.
Please note:
An external number will be dialled via the set
standard connection (VoIP or fixed network).
If the number is to be dialled via the non-
standard connection, enter a star (*) at the
end of the number.
