Configuration program options
11
Upper section: connecting to the PC
You can set the virtual COM port at which the local adapter is connected
in the upper section of the tab.
We recommend leaving the option
No automatic detection at program
deactivated
(as shown). The program then checks the existing
COM ports and determines where the adapter is connected. Manual in-
terface selection is only recommended if there is more than one Gigaset
M105 Data unit connected to the PC.
As soon as the program finds an adapter or identifies the manually se-
lected interface, it sends it the configuration command via the control
lines. This action switches the adapter to configuration status. This is in-
dicated by the
display in the dialog box. Gigaset M105 Data can
only be configured under these conditions. Your Gigaset M105 Data will
automatically switch the adapter back to operating status at the end of the
program.
Lower section: DECT connection
This section indicates whether a radio connection exists and if so, to
which Remote adapter. It also indicates the quality of the connection.
A Remote adapter must be registered before it can be selected here.
