Siemens Gigaset E490, User Manual

Page: 51 / 80

49
Using a handset as a room monitor
Gigaset E490/E495 / AUS / A31008-M2105-C401-1-7619 / registr_sett.fm / 20.08.2010
V
e
rsion 4, 16.0
9
.2005
Using a handset as a
room monitor
If the room monitor is activated, a previously
saved destination number is called as soon
as a set noise level is reached. You can save
an internal or external number in your hand-
set as the destination number.
The room monitor call to an external
number stops after around 90 seconds. The
room monitor call to an internal number
(handset) stops after approx. 3 minutes
(depending on the base station). When the
room monitor is activated, all keys are locked
except the end call key. The handset's
speaker is muted.
When the room monitor is activated, incom-
ing calls to the handset are indicated
with-
out a ringer and are only shown on the
screen. The display and keypad are not illu-
minated and advisory tones are also turned
off.
If you accept an incoming call, the room
monitor is suspended for the duration of the
call, but the function
remains activated.
If you deactivate then reactivate the hand-
set, the room monitor remains activated.
Activating the room monitor and
entering the destination number
v
¢
í
¢
Room Monitor
¤
Change multiple line input:
Room M.
Select On to activate.
Call to
Press the display key
§Edit§
and enter desti-
nation number.
External number: Select number from
the directory or enter directly. Only the
last 4 digits are displayed.
Internal number:
§INT§
¢
s
(select
handset or Call All if all registered hand-
sets are to be called)
¢
§OK§
.
Store number with
§Save§
.
Level
Set noise level sensitivity ( Low or High ).
¤
Press
§Save§
to save the settings.
Warning
u
You should always check the opera-
tion of the room monitor before use.
For example, test its sensitivity.
Check the connection if you are
diverting the room monitor to an
outside number.
u
When the function is switched on, the
handset's operating time is considera-
bly reduced. If necessary, place the
handset in the charging cradle. This
ensures that the batteries do not run
down.
u
Ideally the handset should be posi-
tioned 1 to 2 metres away from the
baby. The microphone must be
directed towards the baby.
u
The connection to which the room
monitor is diverted must not be
blocked by an activated answering
machine.