Siemens Gigaset CL100, Operating Manual

Page: 24 / 34

22
Appendix
Gigaset CL100 / Irland_UK engl / A31008-A221-B101-1-7619 / appendix.fm / 06.11.2003
Appendix
Questions and Answers
If you have questions on the use of your telephone, you can contact us round the clock
at
www.my-siemens.com/customercare . You will also find the most frequently asked
questions and answers below.
What happens if … Possible cause Possible solution
… the display is blank? The handset is not switched
on.
The batteries are flat.
Press the end call key
a
for
approx. 5 secs .
Charge or replace the batteries
(page 8).
… the handset fails to respond
to a key press?
The keypad lock is activated. Press the hash key
R
for approx. 2 seconds to
deactivate the lock (page 8).
… all the icons are flashing in
the display and there is no
connection with the base
station?
The handset is outside the
range of the base.
The handset is not registered.
The base is not switched on.
The cable has not been placed
correctly in the bottom of the
base station.
Move the handset nearer to the
base.
Register the handset
(page 17).
Check the power connector at
the base (page 6).
Check cable placement
(page 6)
… (where multiple handsets
are in use) the handset in the
base station is not charging?
Charging in the base station
only takes place when a phone
call is not being made at the
same time.
Use additional charger unit.
… the handset does not ring? The ringer is switched off.
The ringer volume has been
set to "0".
Call divert has been set to
AUTOMATIC .
Activate the ringer (page 20).
Increase ringer volume
(page 20).
Deactivate call divert
(page 12).
… the caller can't hear me? You've pressed the
INT
key. As
a result the handset has been
"muted".
Activate the microphone again
with MENU, BACK, OK
(page 11).
… the incoming call number is
not displayed even though CLIP
is set?
Sending the phone number
(CLI) has not been enabled.
The caller should request the
network operator to enable the
transfer of his or her phone
number.
... … entries in the caller list
don't show time or date?
Date and time have not been
set.
Set date and time (page 10)
… I can't hear the ringer or
dialling tone?
You have changed the phone
cable on your Gigaset.
When purchasing a new cord
ensure that it has the correct
pin connections (page 26).
… I can hear an error tone
(descending tone sequence)
when keying in?
The function has not worked or
the entry is incorrect.
Repeat the process; watch the
display when doing so and if
necessary check the operating
manual.