53
Appendix
Gigaset C470/C475 / Grossbritannien / A31008-M1902-L101-1-7619 / appendix.fm / 6.8.07
Ve
rs
ion 4,
16
.09.
2005
Appendix
Care
¤
Wipe the base station, charging cradle
and the handset with a
damp
cloth (do
not use solvent) or an antistatic cloth.
Never
use a dry cloth. This can cause a
build up of static.
Contact with liquid
If the handset has come into contact with
liquid:
1.
Switch the handset off and remove
the batteries immediately
.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place
for at least 72 hours
(
not
in a microwave, oven etc.).
4. Do not switch on the handset again
until it is completely dry.
When it has fully dried out, you will nor-
mally be able to use it again.
Questions and answers
If you have any questions about using
your phone, visit us at
www.siemens.com/gigasetcustomercare
at any time. The table below contains a list
of common problems and possible solu-
tions.
The display is blank.
1. The handset is not turned on.
¥
Press
and hold
the end call key
a
.
2. The battery is flat.
¥
Charge or replace the batteries
!
The keys of a handset do not respond when
pressed.
The keypad lock is activated.
¥
Press and
hold
the hash key
#
"Base station x"
flashes
on the display.
1. The handset is outside the range of the
base station.
¥
Move the handset closer to the base sta-
tion.
The base station's range is reduced because
eco mode is activated.
¥
Deactivate eco mode (page 13) or
reduce the distance between the hand-
set and the base station.
2. The handset has been deregistered.
¥
Register the handset (page 40).
3. The base station is not turned on.
¥
Check the base station's mains adapter
Base Search flashes in the display.
No base station turned on or in range.
¥
Move the handset closer to the base sta-
tion.
¥
Check the base station's mains adapter
Handset does not ring.
1. The ringer tone is switched off.
¥
Activate the ringer tone (page 47).
2. Call diversion set to
All Calls
¥
Deactivate call diversion (page 18).
You cannot hear a ringer/dialling tone from
the fixed network.
The phone cord supplied has not been used or
has been replaced by a new cord with the
wrong jack connections.
¥
Please always use the phone cord supplied
or ensure that the jack connections are cor-
rect when purchasing from a retailer
Error tone sounds after system PIN prompt.
You have entered the wrong system PIN.
¥
Reset the system PIN to 0000 (page 49).
Forgetting the system PIN.
¥
Reset the system PIN to 0000 (page 49).
