7
Gigaset AS140
/ IM-eng / A31008-M1696-R101-1-3T19 / Wyoming_IM-eng.fm / 21.06.2007
Care
Wipe the base station and handset with a
damp
cloth
or an antistatic wipe.
Never
use a dry cloth!
This can cause static!
Contact with liquid
If the handset has come into contact with liquid:
1
Switch the handset off and remove the bat-
tery pack immediately
.
2 Allow the liquid to drain from the handset.
3 Pat all parts dry, then place the handset with
the battery compartment open and the keypad
facing down in a dry, warm place
for at least
72 hours
(
not
in a microwave, oven etc.).
4 Do not activate the handset again until it is
dry.
When it has fully dried out you will normally be
able to use it again.
Questions and answers
If you have any queries about the use of your tele-
phone, go to
www.siemens.com/gigasetcustomercare
for assistance 24/7. The table below contains a list
of common problems and possible solutions.
Authorisation
This device is intended for connection to analogue
networks outside the EEA (with the exception of
Switzerland) depending on national type approval.
Country-specific requirements have been taken
into consideration.
We, Siemens Home and Office Communication
Devices GmbH & Co. KG, declare that this device
meets the essential requirements and other rele-
vant regulations laid down in Directive 1999/5/EC.
A copy of the 1999/5/EC Declaration of Conformity
is available at this Internet address:
http://www.siemens.com/gigasetdocs.
Problem
Cause
Solution
Nothing
appears in the
display.
The handset is not
switched on.
Battery pack is
flat.
Press the end call
key
a
for
approx.
5 seconds
or place
the handset in the
base.
Charge/replace the
battery pack (page 2).
No response
to key press,
"
HOLD KEY"
appears in the
display.
The keypad lock is
activated.
Press the hash key
R
for
approx. 2 sec
No wireless
connection to
the base, dif-
ferent icons
flash in the
display.
The handset is
outside the range
of the base.
The handset is not
registered.
The base is not
switched on.
Cords not routed
correctly
Move the handset
closer to the base.
Register the handset
Check the power con-
nector at the base
Check cord routing
(page 2).
!