Siemens FUG1010 IP65 NEMA 4X, Operating Instructions Manual, Page: 144 / 271

Troubleshooting
10
10.1 Troubleshooting
The following is list of troubleshooting tips and messages that you may encounter. They
include explanations and, in some cases, a recommended action. If a problem seems
unsolvable, contact your local Siemens Ultrasonic Flow Representative for expert help at:
http://www.automation.siemens.com/partner ( http://www.automation.siemens.com/partner
).
Table 10- 1 Troubleshooting Tips
Error or Message Probable Cause Solution
Memory Full! Response to an attempt to save site
data, when data memory is full.
Delete an obsolete site or clear
Datalogger memory to make room for
the new data.
Memory Corrupted! Memory read error occurred while
accessing the active site data.
Refer to F4 reset procedure in the
Operation Instructions manual.
Chan Not Setup Response to an attempt to invoke an
operation that requires a channel to be
enabled.
Enable the channel [Channel Setup -
Channel Enable - Yes]. Note that a
channel cannot be enabled until an
"Install" operation is completed.
Clr Active Memory? Response to pressing the F4 key. Use the F4 function to restore
operation if a severe event (e.g., a
violent power surge) disrupts system
operation.
Clr Saved Data? [Clr Saved Data?] only appears after
pressing the <Down Arrow> in
response to [Clr Active Memory?].
Answering Yes to [Clr Saved Data?]
will erase ALL saved data. To invoke in
RS-232 serial mode, type @@@ and
then press <Enter> key.
<EOT> Response to a request to output
Datalogger data to the printer or the
Graphics screen when no Datalogger
data exists or at the end of a
transmitted file.
Set up the Datalogger.
No Sites - Press <ENTER> Response while trying to recall/delete a
site setup when no sites are stored.
Create site.
Security Response upon changing previously
entered data when security switch is in
[Disable] position or security code has
been entered.

Change switch position to [Enable].

Enter previously set security code.
RTC Error Component level problem.

Meter requires service. Request
RMA.
FUG1010 IP65 NEMA 4X
Operating Instructions, 01/2013, A5E02951519-AC
143