Siemens FUG1010 IP65 NEMA 4X, Operating Instructions Manual, Page: 119 / 271

Functions
7.7 Analog Input Setup
FUG1010 IP65 NEMA 4X
118
Operating Instructions, 01/2013, A5E02951519-AC
Assigning a function to the voltage output:
1. From the [Analog Out Setup] menu, press <Right Arrow> to access the [Vo1] option list.
2. Move the cursor to the desired data function by pressing <Up/Down Arrow>.
3. To store selection press <ENTER>.
Note
Refer to drawing 1010N-7-7 in Appendix A for Analog output connections.
See also
Installation/Outline Drawings (Page 193)
7.7 Analog Input Setup
The optional Analog Input Setup function assigns an active analog input to a measurement
channel/path. The flow meter provides four DC current input ports for single channel and
Dual Path units. The DC current input ranges from a zero level of 4mA to a full scale of
20mA. The [Analog Inp Setup] menu cell allows you to enable this port and then span it to
any desired scaling.
For example, when using the analog input for pressure the numeric variables might be
spanned as follows: 4mA=14.7 PSIA and 20mA=1014.7 PSIA.
Note
The flow meter expects "absolute" pressure. If the external device reports "gauge pressure"
then make sure to span the pressure input so that 4mA represents 1 ATM (14.7 PSIA or
1.014 BARA) and not 0.0.
The various flow meter models allow you to associate the analog input to active system
variables such as specific gravity, viscosity and others (see table below).
Note
Refer to the Installation Drawings or I/O Module markings for the locations of these inputs
and wiring procedures.