Siemens FUG1010 IP65 NEMA 4X, Operating Instructions Manual, Page: 117 / 271

Functions
7.6 Analog Out Setup
FUG1010 IP65 NEMA 4X
116
Operating Instructions, 01/2013, A5E02951519-AC
7.6 Analog Out Setup
The flow meter provides current, voltage and pulse-rate analog outputs. The [Analog Out
Setup] menu allows you to assign data functions for these signals. The transmitter terminal
strip contains the analog output terminals.
Table 7- 9 Analog Outputs
Io (Isolated Current) 4 to 20mA varies in proportion to an assigned
data function.
Vo (DC Voltage) 0 to 10 VDC varies in proportion to an assigned
data function.
Pgen (TTL Logic) 0 to 5000 Hz varies in proportion to an assigned
data function.
Digital Pgen User selective pulses per unit flow.
Table 7- 10 Analog Out Setup Data Categories
Vfo System spanned volumetric/mass flow rate
Vfo2 Additional spanned volumetric/mass flow rate
Vfab System spanned and signed absolute flow
Vs Spanned gas sonic velocity
Valc Received signal amplitude
Vtrb Relative degree of gas turbulence
Vsg Spanned specific gravity
Base S.G. Spanned S.G. referenced to user temperature
Viscosity Gas viscosity in centistoke units
Iin1, Iin2, Iin3, Iin4 Represents a re-transmit of the analog input
signals (e.g. Pressure and Temp inputs can be
transmitted on the 4-20mA output).
Note
For Multi-Path flow meters: "1" = Path 1, "2" = Path 2, "3" = Path 3, "4" = Path 4 and "S"
represents the system or average channel. These characters appear to the left of the option
list parameter.
Io Output Functions
4-20mA outputs also provide a fault indication by dropping to 2mA if assigned to flow rate
and under fault conditions.