8
■
The distance between the top edge of the oven and the
bottom edge of the extractor hood must meet the
requirements of the extractor hood manufacturer.
■
Ensure that the appliance is not moved again after set up.
The distance from the high output burner or wok burner to
the fronts of the adjacent units or the wall must be at least 50
mm.
Measures to be noted during transport
Secure all mobile parts in and on the appliance using an
adhesive tape that can be removed without leaving any traces.
Push all accessories (e.g. baking tray) into the corresponding
slots with cardboard at the edges, in order to avoid damaging
the appliance. Place cardboard or similar between the front and
rear side to prevent knocks against the inside of the glass door.
Secure the door and, if available, the top cover to the appliance
sides using adhesive tape.
Keep the original appliance packaging. Only transport the
appliance in the original packaging. Observe the transport
arrows on the packaging.
If the original packaging is no longer available
pack the appliance in protective packaging to guarantee
sufficient protection against any transport damage.
Transport the appliance in an upright position. Do not hold the
appliance by the door handle or the connections on the rear, as
these could be damaged. Do not place any heavy objects on
the appliance.
Your new cooker
Here you will learn about your new cooker. We will explain the
control panel, the hob and the individual operating controls.
You will find information on the cooking compartment and the
accessories.
General information
The design depends on the respective appliance model.
Cooking area
Here is an overview of the control panel. The design depends
on the respective appliance model.
Hotplate controls
You can use the four hotplate controls to control the heat
output provided by each hotplate.
At the end of the settings range there is a limit stop. Please do
not turn the knob beyond this stop.
Explanations
1
Hob cover
2
Hob
3
Hotplate knob
4
Function selector, Operating switches and display
panel, Temperature selector
5
Appliance cooling
6
Oven door
7
Plinth drawer
Explanations
1
Standard burner
2
Economy burner
3
High output burner
4
Standard burner
Setting
Function/gas burners
Ú
Off position
The hotplate is switched off.
:
Ignition position
Ignition position
•
–
Settings area
High flame = highest power
Economy flame = lowest output
