Siemens Flender FLUDEX 4600 FAD Series, Operating Instructions Manual

Page: 14 / 38

14
FLUDEX 4600 en
Operating instructions 10/2017
When machining the finished bore the parts must be carefully aligned. For the permissible radial and axial
runout errors and the permissible cylindricity tolerances, see DIN ISO 286. The parts must be fitted on the
marked faces (
).
In case of part 2/3, part 4 and part 9 great caution is necessary owing to the rotating
cams.
The maximum permissible bore diameters (see table 1) are designed for drive­type
fastenings without taper action to DIN 6885/1 and must not under any circumstances
be exceeded. The finish­machined bores must be 100 % checked with suitable
measuring equipment.
If other shaft­hub connections (e.g. taper or stepped bore) are to be used instead of the flanged sleeve
connections provided for, Flender must be consulted.
Drive­type fastenings with taper action are not permissible.
A IT8
IT6
Part 1
B IT8 C IT8 D IT8
B
A
C
D
IT6 IT6 IT6
B IT8
E F G H
E IT8 F IT8
G IT8 H IT8
IT6 IT6 IT6 IT6
Part 2 Part 2/3
Part 5 Part 9 Brake drum (13; 32) Brake disk (32)
Part 4
3.2
3.2 3.2
3.2
3.2
3.2 3.2 3.2
Fig. 4: Finished bore
Table 1: Maximum bores of the N­EUPEX add­on coupling
FLUDEX N‐EUPEX Maximum bore D
1
Size Size Part 1
Part 2
Part 2/3
Part 4 Part 5 Part 9
Brake drum
(13; 32)
Brake disk
(32)
222 110 - 38 48 42 38 38 42
297 125 55 45 55 60 48 55 60
342 140 60 50 60 70 52 60 70
395 225 - 85 90 80 - 80 80
450 250 - 95 100 90 - 80 90
516 315 - 120 - 100 - 100 100
590 315 - 120 - 100 - 110 100