Siemens FCT010/DSL, Operating Instructions Manual, Page: 173 / 180

Table C-19 Simulation
Modbus ad‐
dress Data type /
Size [bytes] Parameter Description Default value
[unit] Value
range Access
level
2764 Float / 4 Mass flow Simulation
Value Set mass flow simulation val‐
ue.
The mass flow will be set to
this value on all outputs,
if Simulation Mass Flow is
enabled 0 [kg/s] -1023 to
+1023 Read /
Write
2766 Float / 4 Density Simulation
Value Set density simulation value.
The density will be set to this
value on all outputs, if Simu‐
lation Density is enabled 1000 [kg/m 3 ] -20000 to
+20000 Read /
Write
2768 Float / 4 Media Temperature
Simulation Value Set media temperature simu‐
lation value. The media tem‐
perature will be set to this
value on all outputs if Simu‐
lation media Temperature
is enabled 0 [°C] -50 to +200 Read /
Write
2770 Float / 4 Frame Temperature
Simulation Value Set frame temperature simu‐
lation value.
The frame temperature will
be set to this value on all out‐
puts if Simulation Frame
Temperature is enabled 0 [°C] -50 to +200 Read /
Write
2772 Float / 4 Volume flow Simula‐
tion Value Set volume flow simulation
value.
The volume flow will be set
to this value on all outputs,
if Simulation Volume Flow
is enabled m 3 /s -65 to +65 Read /
Write
2780 Unsigned / 2 Enable Simulation Activate simulation.
Select one of the following
values:
• Bit 0: Mass flow
• Bit 1: Density
• Bit 2: Volume flow
• Bit 3: Media temperature
• Bit 4: Frame temperature 0 0 to 63 Read /
Write
Modbus communication FCT010
C.4 Modbus holding registers tables
SITRANS MASS 2100 & FC300 (FCT010/DSL)
Operating Instructions, 06/2020, A5E39788682-AB
173