Mounting
2
6 | 14
Siemens Industry, Inc.
A6V10315036_d_en_--
Building Technologies Division
2018-03-16
2 Mounting
The NAC module (1A/2B) FCI2011 is installed on the periphery board as shown and
screwed onto the back box. Slot X901 is also used for the releasing module.
Figure 1: Installing the NAC module on the periphery board
1
Periphery board (250p) or periphery board (500p)
2
Threaded standoffs on back box
3
NAC module (1A/2B) FCI2011
4
2x fixing screw
X901
Slot in periphery board
X5
Connection terminal on NAC module (1A/2B)
1. Plug the NAC module (3) into slot X901 on the periphery board as shown.
2. Fasten the NAC module to the threaded standoffs (2) in the back box using the two
fixing screws (4).
3. Wire up the NAC module according to the pin assignment.
