Basic settings
en
23
22 Basic settings
You can configure the basic settings for your appliance to meet your needs.
22.1 Overview of the basic settings
Display
Setting
Value
Childproof lock
- Manual.
1
Automatic.
– Switched off.
Audible signals
– Confirmation and fault signals are switched off.
– Only the fault signal is switched on.
– Only the confirmation signal is switched on.
– All signal tones are switched on
1
.
Energy consumption display
Shows the total energy consumption
between switching the hob on and off in
kWh.
The accuracy of the display depends on vari-
ous factors such as the voltage quality of the
power supply.
– Switched off.
1
– Switched on.
Select the setting in accordance with the
height about sea level:
- - Decrease.
- Basic setting.
- - Increase.
Automatic switch-off of the cooking zones.
– switched off.
1
- - minutes until the appliance switches off auto-
matically.
Duration of the timer end signal tone
– 10 seconds
1
– 30 seconds
- 1 minute
Power limitation
Enables the total power of the hob to be lim-
ited, if necessary, based on the conditions of
your electrical installation. The available set-
tings depend on the maximum power of the
hob. You can find precise information on the
rating plate. If the function is active and the
hob has reached the set power limit, is dis-
played and you cannot select a higher power
level.
- Switched off. Maximum power of the hob
1
.
- 1000 W. Lowest power setting.
. - 1500 W.
...
- 3000 W. Recommended for 13 A.
. - 3500 W. Recommended for 16 A.
- 4000 W.
. - 4500 W. Recommended for 20 A.
...
- Maximum power of the hob.
powerMove Plus
Allows you to change the preset power levels
for the three cooking areas of the flexible
cooking zone.
Select one of the two cooking zones, set the
required power level in the settings area and
touch to confirm the new power level and
select the next cooking zone.
- Preset power level for the front cooking zone.
- Preset power level for the middle cooking zone.
. - Preset power level for the rear cooking zone.
Cookware test
You can use this function to test the quality
of the cookware.
- Not suitable.
- Not optimal.
- Suitable.
flexInduction
Change the switch-on mode for the Flex
Zone.
- As two independent cooking zones.
- As a connected cooking zone.
1
Connect the wireless cooking sensor to the
hob.
- Connected correctly.
- Not connected correctly due to a transmission error.
- Not connected correctly due to a cooking sensor
fault.
1
Factory setting
