Siemens ET8..LMV1, User Manual

Page: 7 / 24

Basic operation
en
7
Notes
¡
Dark areas in the glow pattern of the hotplate are
part of the technical design. They do not affect the
functionality of the hotplate.
¡
The hotplate regulates the temperature by switching
the heat on and off. The heat may also switch on
and off when at the highest setting.
¡
With multi-circuit hotplates, the heating of the inner
filament circuits and the heating of the activations
may switch on and off at different times.
–
This protects easily damaged components from
overheating.
–
The appliance is protected against electrical
overload.
–
Better cooking results are achieved.
Combi-cooking zone
The combi-cooking zone allows you to combine the
single-circuit and the dual-circuit hotplate with the
bridge heating element. The two hotplates can also be
operated independently of each other.
2
3
1
1
Single-circuit hotplate
2
Dual-circuit hotplate
3
Bridge heating element
Combination Activation Suitabil-
ity
Small extended
cooking zone: com-
bination of 2 and 3 Use to activate
the bridge heating
element.
lights up brightly.
Small
roaster
Small
teppan-
yaki.
Large extended
cooking zone: com-
bination of
1 and 3 and 2 Touch ⁠.
lights up brightly.
Large
roaster
Large
teppan-
yaki
Large
grill plate
The small extended cooking zone (2 and 3) and the
single-circuit hotplate (1) can also be operated inde-
pendently with different heat settings. This produces dif-
ferent temperature areas, for example for the large
roaster, the teppanyaki or the grill plate.
With the small extended cooking zone you can fry one
food while simultaneously using the single-circuit hot-
plate to keep another warm.
Tip:
Suitable cookware is available from customer ser-
vice or our online-shop.
4.5 Residual heat indicator
The hob has a two-stage residual heat indicator for
each hotplate. Do not touch the hotplate while the re-
sidual heat indicator is lit up.
Display Meaning
The hotplate is so hot that you can
keep small dishes warm or melt cook-
ing chocolate.
The hotplate is hot.
5 Basic operation
5.1 Switching the hob on or off
The main switch is used to switch the hob on and off.
If you switch the appliance back on again within
4 seconds after switching off, the hob will start up with
the previously stored settings.
5.2 Switching on the hob
▶
Touch .
a
The indicator lamp above lights up.
a
The displays for the controls and the heat setting
displays light up.
a The hob is ready for use.
a
The two front hotplates are selected.
a
The two rear heat setting indicators light up
brightly.
5.3 Switching off the hob
The hob will switch off automatically when all hotplates
have been switched off for a while (10-60 seconds).
▶
Touch .
a
The indicator lamp above goes out.
a The displays go out.
a
All hotplates are switched off.
a The residual heat indicator remains on until the hot-
plates have cooled down sufficiently.
5.4 Setting the hotplates
To set a hotplate, it has to be selected.
The left-hand hotplates are selected with the control
panel on the left side and the right-hand hotplates with
it on the right.
Heat setting
1 Lowest setting
9 Highest setting
. Every heat setting has an intermediate
setting, e.g. 4.5.
5.5 Selecting heat settings
Requirement:
The hob is switched on.