Cleaning and maintenance
en
9
Cleaning the metal mesh grease filters
These instructions apply to several appliance variants. It
is possible that individual features are described which
do not apply to your appliance.
:
Warning – Risk of fire!
Grease deposits in the grease filter may catch fire.
Clean the grease filter at least every 2 months.
Never operate the appliance without the grease filter.
Notes
■
Do not use any aggressive, acidic or alkaline
cleaning agents.
■
When cleaning the metal mesh grease filters, also
clean the holder for the metal mesh grease filters in
the appliance using a damp cloth.
■
The metal mesh grease filters can be cleaned in the
dishwasher or by hand.
By hand:
Note:
You can use a special grease solvent for
stubborn dirt. It can be ordered via the Online Shop.
■
Soak the metal mesh grease filters in a hot soapy
solution.
■
Clean the filters with a brush and then rinse them
thoroughly.
■
Leave the metal mesh grease filters to drain.
In the dishwasher:
Note:
If the metal mesh grease filters are cleaned in the
dishwasher, slight discolouration may occur. This has
no effect on the function of the metal mesh grease
filters.
■
Do not clean heavily soiled metal mesh grease filters
together with utensils.
■
Place the metal mesh grease filters loosely in the
dishwasher. The metal mesh grease filters must not
be wedged in.
Removing metal grease filter
1.
Open the filter cover by pulling it downwards.
Notes
– The filter cover is heavy. Hold the filter cover with
both hands.
– Open the filter cover slowly and carefully.
2.
Press the lock on the metal grease filters.
Note:
To avoid causing damage, do not bend the
metal grease filter.
3.
Take the metal grease filter out of the holder.
Note:
Fat may accumulate in the bottom of the metal
grease filter. Hold the metal grease filter level to
prevent fat from dripping out.
4.
Clean the appliance from the inside.
5.
Clean the metal grease filter and let it dry before
refitting it.
Installing the metal mesh grease filter
1.
Insert metal grease filter.
While doing this, place your other hand under the
metal grease filter.
2.
Fold up metal grease filter and engage the lock.
3.
Close the filter cover upwards.
Note:
Ensure that the filter cover lock engages
correctly.
Replacing the batteries in the remote control
1.
Undo screws.
2.
Remove cover.
3.
Remove the batteries.
4.
Correctly insert the new batteries (23AE 12 V).
5.
Dispose of flat or faulty batteries according to local
regulations.
Note:
Do not dispose of batteries in general household
waste.
