9 / 22
Siemens
Desigo Touch and Web
CM111029en_04
Building Technologies
Commissioning – Touch panel commissioning – Step-by-step
2014-08-15
1.4 Touch panel commissioning – Step-by-step
1.4.1 About
procedures
The following step-by-step procedures consider all actions, settings, etc. It is pos-
sible that, in the past, you may have applied and now wish to continue a different
procedure. The procedure described here merely shows the procedure identified
as best by development.
1.4.2 Procedure
1.
If not yet done: Connect the Desigo touch panel to the corresponding network
plug using the
network cable
(RJ45).
2.
If not yet done: Connect to
power
.
3.
Wait for the touch panel to
start
.
---> This process may take a few seconds; the
Language
page is displayed.
4.
Select the
language
.
---> 16 languages are integrated. English is the default language.
5.
Save
with
Next
.
---> The page “Network Settings – IPv4”
opens
.
Note
Two ways are available for the following step:
a. Automatically using DHCP (self-explanatory).
b. Manual via the alphanumeric keypad.
Below, we describe how to proceed with a manual entry. The procedure for IPv4 is
virtually automatic for the DHCP method.
