©
Siemens AG 2003, E:\Auftrag\Siemens\Mobile
Phones\CX65 Ulysses\us\LA\CX65_Startup.fm
17
Getting started
VAR Language: Am
erican; VAR
issue date: 16-Februar-2004
left page (17)
of CX 65 Ulysses us-en, A31008-H7100-A1-1-7619 (24.03.2004, 11:03)
Charging the battery
Charging the battery
The battery is not fully charged
when delivered. Plug charger cable
into the bottom of the phone, plug
power supply unit into a mains
power socket and charge for at least
two hours
.
Y
Display during charging.
Charging time
A flat battery will be fully charged
after about 2 hours. Charging is only
possible within a temperature range
of +5 °C to 45 °C. If the temperature
rises/falls 5 °C above/below this, the
charge symbol flashes a warning.
The mains voltage specified on the
power supply unit must not be
exceeded.
Operating time
The operating time depends on the
respective conditions of use.
Extreme temperatures considerably
reduce the phone’s standby time.
Avoid placing the phone in the sun
or on a heater.
Call time: 100 to 330 minutes
Standby time: 60 to 300 hours.
Charge icon not visible
If the battery has been fully dis-
charged, the charge icon is not
immediately visible when the power
supply is plugged in. It will appear
after up to two hours. In this case the
battery will be fully charged after
3 to 4 hours.
Only use the plug-in power supply
included in delivery!
Display while in service
Charge level display during opera-
tion (empty-full):
V
W
X
A beep sounds when the battery is
nearly discharged. The charge level
of the battery is only displayed cor-
rectly after an uninterrupted charg-
ing/discharging cycle. You should
therefore
not remove the battery unnec-
essarily
and where possible
not finish
the charging process prematurely.
Additional information
The power supply unit heats up when used
for long periods. This is normal and not
dangerous.
If the battery is removed for longer than
30 seconds, the clock must be reset.