Siemens COMOS, Operating Manual

Page: 107 / 156

8.8.4 Updating attachment type combinations
The combinations that you have predefined yourself update automatically.
If you have subsequently added or removed a pipe part from the "Pipe parts" tab, update the
standard combinations of the fastening tables manually. COMOS recognizes inconsistencies
and corrects these.
Procedure
Click the "Update" button.
8.8.5 Evaluation sequence
The "Fastening table" tab is evaluated if two pipe parts belonging to the same pipe spec are
interconnected in the engineering data.
Procedure
1. For both pipe parts, COMOS checks which attachment types have been set on the
"Connector <1-n>" tab.
2. The attachment types are determined.
3. The fastening part is determined for the combinations of both attachment types with the aid
of the fastening table.
4. The fastening part is used.
5. Steps 1-4 are executed recursively at every selected fastening part used.
8.8.6 Adding standard combinations
The standard combinations of attachment types are stored in the following object in the "Default
attachment connections" table:
"@20 > C90 > A50 > A10 Attachment type combinations"
● The following standard table is available in the "First attachment type" column and "Second
attachment type" column:
"Standard tables > Y10 > M23 > A20 > Y10M23N00030 Attachment types"
● The following standard table is available in the "Function code group" column:
"Standard tables > Y10 > M23 > A20 > Y10M23N00031 Function code groups"
If you have expanded the standard table, enter the new combinations in the "Attachment type
combinations" object.
Configuring pipe specs
8.8 "Fastening table" tab
PipeSpec Designer
Operating Manual, 09/2014, A5E32076948-AA
107