Siemens AXIOM Iconos R200, Operator'S Manual, Page: 70 / 238

System Operation
System Settings
18
/ 32
AXD3-340.620.13.01.02 Operator Manual
Setting orthogonal projection (oblique proj/- 0°)
◆
Press this key
– If the central beam is orthogonal to the receptor unit, the LED lights up;
– The display for oblique projection indicates ”0°”.
Reading off the projection angle
System remote
control console
◆
Read the angle in degrees (“°“) on the display.
Tableside control
panel
◆
Read the display in degrees (“°”).
Tabletop
˚
Warning
Avoid a seated working position directly at the system with your legs/knees un-
der the head/foot-end crossbeam.
The system monitors the safety distance only with regard to the floor. Collisions
can occur with other room equipment and mobile objects such as foot switch-
es, steps, refuse bins, etc.
◆
Make sure before you actuate movements that no obstructions are present.
◆ Then control the system with increased caution.
If you have set the footboard in an exceptional case on the head end of the
tabletop, the safety distances which your system maintains automatically
are impaired.
◆ Actuate movements then only with direct visual control.