Siemens Ardoptix PT 140 AF1, Operating Manual, Page: 36 / 68

s
Operating manual
28
TU Inner device temperature
1NTY.
Signal intensity
M.TR.1 Triggered by ATD function Lambda 1*
M.TR.2 Triggered by ATD function Lambda 2*
M.TR.Q Triggered by ATD function two-
colour/ratio mode*
DIRT Dirt Alert
A.AC.1 Measuring time ATD Lambda 1*
A.AC.2
Measuring time ATD Lambda 2 *
A.AC.9
Measuring time ATD
two colour/ratio mode
*
BU2.F
Buzzer function
LVL.
Switch direction “Level” (LED acti-
vated if limit exceeded)
LVL.-
Switch direction “Level” (LED
/ out-
put inverted)
RN6.
Switch direction “Range” (LED acti-
vated if range exceeded)
RN6-
Switch direction “Range” (LED /
output inverted)

BU2.T
Buzzer switching
threshold
Temperature limit
(only available at function “Level”)

BU2.H
Buzzer signal
threshold
Hyst/- relative to signal threshold
(only available at function “Level”)

BU2._
Buzzer lower limit of
range
Lower limit of range for switch signal
(only available function “range”)

BU2.~
Buzzer upper limit of
range
Upper limit of range for switch signal
(only available function “range”)

BUZ.L
Buzzer delay time

BU2.M
Buzzer hold time

END
End
exit menu

* Only available with ATD function
16.1.5 General Functions
(Configuration layer: C011)
Parameter Function Explanation
A.OFF
Auto switch-off
OFF automatic switch-off function deac-
tivated
1-60
time period in minutes for auto
switch-off delay
A.STR.
Auto temp. data ouput
OFF
automatic temp. data output is off
ON temp. data output at PC terminal

A.CYC.
Cycle for auto temp.
data output
Select cycle time in s

ADDR.
Device address
Enter address of device for non-terminal
mode

DISP.
Display control
"ON" Display panel indicates "on"
IA1
Indicated temperature reading ac-
cording to operating mode

UNIT
temperature unit
°(
degrees Celsius
°F degrees Fahrenheit
MENU
Menu-Mode
NORM
With

marked parameter are
shown
FULL
All parameters are shown
END
End
exit menu