Siemens Ardoptix PT 140 AF1, Operating Manual, Page: 33 / 68

s
Operating manual
25
T.DEL
time delay **
For ATD function, see Chap. 15.2.4

T.ACT
Sampling time **
For ATD function, see Chap. 15.2.4

T.DIS
cut-off interval **
For ATD function, see Chap. 15.2.4

T.OUT
Timeout**
For ATD function, see Chap. 15.2.4

LI. 1
Limit 1**
For ATD function, see Chap. 15.2.4

LI. 2
Limit 2**
For ATD function, see Chap. 15.2.4

F-PR
Average weighting **
For ATD function, see Chap. 15.2.4

TSP~
Plausibility
threshold **
For ATD function, see Chap. 15.2.4

TSP~
Plausibility
threshold **
For ATD function, see Chap. 15.2.4

ANO
Mode of display **
T=0 show lower limit of temp. range dur-
ing running measurement
T.HLD Hold previous temp. reading during
running measurement

A.RST
Auto reset**
For ATD function, see Chap. 15.2.4

CH.L.2
Set Li2 check on tAct**
For ATD function, see Chap. 15.2.4

END
End
Exit menu
* Only available with Min/Max and Double Max modes
** Only available with ATD function
16.1.3 Temperature measurement lambda 2
(Configuration layer:
C003
)
By default, some parameters are suppressed to facilitate operation.
Parameter Function
Explanation
E.TB.
1
Array size
Use array with 1-10 entries or enter material
constant directly into the pyrometer
EPS.2
Emissivity factor L2
Enter material constant directly into the py-
rometer
E.IDX
Memory position
Choose an entry from the material constants
array

E. 01
Assign material
constants
Customize the array; assign a value to each of
the material constants in the array. Possible
indexes depend on the size of the array

TAU.2
Transmittance factor
L2
BAC.2
Ambient temperature
compensation

BAC.T
Temp. of ambient
source of radiation

BAC.%
Influence of ambient
IR radiation
The reflected thermal radiation from the sur-
roundings as a portion of the total IR radiation
collected by the sensor in %

LIN.2
Temperature offset
using linear
OFF off
2-10 number of nodes used
