Siemens AlgoPilot B3Q661, Operating Instructions Manual

Page: 34 / 140

Operating instructions Œ•Ž
34
Building Technologies A6V10225450_b_en_--
Fire Safety 2017.09.07
Switching DETECTORS OFF/ON
When does a de-
tector have to
be switched off?
Only if it is damaged or defective until the point at which the detector is replaced.
i
·
A switched off detector
cannot produce messages
.
·
It is only a good idea to switch off detectors if the corresponding ZONE is switched on.
Operating ac-
cess
If you still don't have operating access when starting operation work, the release procedure is
automatically called up.
Switching off
detectors using
menu
Perform the following steps to switch OFF an individual detector:
Step Action Result / Comment
1 Press
softkey
<Operate..>
The main menu appears on the display.
2 Press
softkey
<Browse..>
The sub-menu is displayed.
3 Press
softkey
<Browse FIRE
DETECTION..>
The AREAS menu is displayed
Use the scroll keys to select the area you
want.
4 Press
softkey
<Select SECTION
¯
>
The SECTIONS menu is displayed
Use the scroll keys to select the section
you want.
5 Press
softkey
<Select ZONE
¯
>
The ZONES menu is displayed
Use the scroll keys to select the zone you
want.
6 Press
softkey
<Select ELEMENT
¯
>
The ELEMENTS menu is displayed
Use the scroll keys to select the element
you want.
7 Press
softkey
<Other functions..>
8 Press
softkey
<Element -> OFF>
Implementation messages
'
Implementing ...
' - and -
'
Implemented
'
NOTE:
If all the elements of an AREA are OFF, the corresponding zone is automatically switched off,
and all element Isolation messages are deleted.
In this case, reactivation is only possible at 'ZONE' level.