iii
COM-00-21-03 OCTOBER 2021
Version No.: A
FCC RULES COMPLIANCE
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1.
This device may not cause harmful interference, and
2.
This device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by Siemens could void the user’s
authority to operate the equipment.
RF EXPOSURE WARNING
This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled
environment. This transmitter must follow the specific operating instructions for satisfying RF
exposure compliance. This transmitter must be at least 20 cm from the user and must not be co-
located or operating in conjunction with any other antenna or transmitter.
NOTE
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
