ULTRAMAT 6 / OXYMAT 6 / CALOMAT 6 / ULTRAMAT 23 / OXYMAT 61
Schnittstelle PROFIBUS DP / PA Interface
A5E00054148-03
98
3.1.6
Physical Block with ULTRAMAT, OXYMAT and CALOMAT
Device-specific properties can be displayed/set using parameters in the physical block.
Rel.
Index
Parameter
Description
8 SOFTWARE_REVISION
Firmware version of the device
9 HARDWARE_REVISION
Hardware version of the device
10 DEVICE_MAN_ID
Manufacturer’s code
SIEMENS AG = 42
11 DEVICE_ID
Manufacturer’s identification:
e.g. ULTRAMAT 23
12 DEVICE_SER_Num
Serial number of the device
13 DIAGNOSIS
Bit encoded standard diagnostic messages
15 DIAGNOSIS_MASK
Bit mask indicating which DIAGNOSIS bits are supported.
17 DEVICE_CERTIFICATION
Details about certification in plain text
18 WRITE_LOCKING
Write protection function. Write access is refused with the error
code access denied.
19 FACTORY_RESET
Command to trigger reset functions in the device:
•
0:
No action.
•
1:
Reset all parameters to the factory settings. Except for
the set station address, the IDENT_NUMBER
parameter and the ST_REV. The device shows the
following cold start in the corresponding bit of
DIAGNOSIS for 10 sec.
•
2506: Initiate a device warm start. The device shows the
following cold start in the corresponding bit of
DIAGNOSIS for 10 sec.
•
2712: Reset the station address to the normal PROFIBUS
default address 126.
20 DESCRIPTOR
Option to store a description of the device within an application.
21 DEVICE_MESSAGE
Option to store a message about the device within an application.
22 DEVICE_INSTAL_DATE
Installation date of the device
23 LOCAL_OP_ENA
Enable local operation
24 IDENT_NUMBER
Each PROFIBUS device must check an identification number
issued by the PNO in the
. The user sets the
configuration behavior of the device here:
•
0: Only the PROFILE identification number is acknowledged
positively.
•
1: Only the device-specific identification number is
acknowledged positively.
36 DEVICE_CONFIGURATION
Description of the device configuration