7.3
Configuring
7.3.1
Configuration information
Mounting measuring sensors
Cross-circuits between the measuring sensors must be avoided by means of suitable cable
installation.
Transmission ratio or shaft fracture monitoring
In certain applications, it can be necessary to set a transmission ratio. The following
arrangement of the initiators or the encoder is necessary here:
• The speed to be monitored on the encoder or on initiator 1 (E1) must always be greater than
or equal to the speed to be monitored on initiator 2 (E2).
• The set speed limits on the display always refer to the encoder or to initiator 1 (E1) when a
transmission ratio is set.
• If the gear unit switched between E1 and E2 does not have an integer ratio, it can be adjusted
appropriately by modifying the resolution settings E1/E2 (pulses/rev. or mm).
(QFRGHUQೢ
,QSXWRQGLVSOD\UDWLR
0RWRU *HDUZKHHO
*HDUZKHHO
,QLWLDWRUQೣ
7UDQVPLVVLRQUDWLR
*HDUXQLW
,QLWLDWRUQೢ
6KDIW
¾ QೢQೣ [
(
(
¾ [
]%Q 8PLQQ 8PLQ
8PLQ
8PLQ
¾
Qೢ
Qೣ
QೢุQೣ
This arrangement is also used to detect a shaft fracture. If the measuring signals of the
measuring sensor do not agree with the measuring sensor on the shaft in accordance with the
ratio, the device switches immediately to a safe fault state.
Operation
7.3 Configuring
3TK2810-1 safety-related speed monitor
Equipment Manual, 05/2020, NEB926246402000/RS-AE/007
57
