Setting SCSI addresses (IDs)
Settings in SCSI Setup
A26361-D970-Z120-3-7619
53
SCSI-Setup
The BIOS of the ultra-wide SCSI controller includes a menu-driven
SCSI Setup
.
This program allows you to change almost all of the option settings of the SCSI
controller and the connected SCSI devices.
When you boot the system a SCSI-BIOS message listing the SCSI devices
connected is displayed.
i
If an SCSI-BIOS error message appears or problems arise with SCSI
devices, please refer to the chapter entitled "
SCSI controller
" and „
“.
You may find further information in the documentation of your SCSI
device.
If you are unable to trace or rectify the error, please contact your dealer
or our service.
Starting the SCSI Setup
You must enable the ultra-wide SCSI controller in the system BIOS to be able to
call the
SCSI-Setup
. Call the
BIOS-Setup
and set the
SCSI Controller
field in the
PCI
Configuration
menu to
enabled
.
Ê
Start your PC and press key combination and , when the following message
appears:
Press <Ctrl> <A> for SCSI Select (TM) Utility!
The first menu of the
SCSI setup
,
Configure/View Host Adapter Settings
and
SCSI Disk
Utilities
is displayed.
Working with the keyboard
Use the following keys when running the program:
↑↑↑↑ ↓↓↓↓
to make selections
↵
to accept a selection
ESC
ESC
ESC
ESC
to call the previous menu and to terminate the
SCSI setup
.
F6
F6
F6
F6
to reset to the default settings
F5
F5
F5
F5
to toggle display between color and monochrome mode
Also note the status line at the bottom of the screen.
Summary of Contents for D970
