SICK WSE16 Series, Operating Instructions Manual

Page: 5 / 110

1 Safety information
1.1 General safety notes
■
Read the operating instructions before commissioning.
■
Connection, mounting, and configuration may only be performed by trained
specialists.
■
Not a safety component in accordance with the EU Machinery Directive.
■
When commissioning, protect the device from moisture and contamination.
■
These operating instructions contain information required during the life cycle of
the sensor.
1.2 Notes on UL approval
The device must be supplied by a Class 2 source of supply.
UL Environmental Rating: Enclosure type 1
2 Intended use
The WSE16 is an opto-electronic through-beam photoelectric sensor (referred to as
“sensor” in the following) for the optical, non-contact detection of objects, animals, and
persons. A sender (WS) and a receiver (WE) are required for operation. If the product is
used for any other purpose or modified in any way, any warranty claim against SICK AG
shall become void.
3 Operating and status indicators
20
Ø 12,9
Ø
4
,1 3
9
,9
5
5
,4
4
5
,5
5
42
29,9
6
3
6,5
15
27,8 7,7
7,8
7
,2
35,5
4,1
8
,3
5
5
,7
4
3
1
6
2
5
7
20
Ø 12,9
8
,3
3
4
,5
1
6
Figure 1: Dimensional drawing 1, cable
1
Center of optical axis, sender
2
Center of optical axis, receiver
3
Fixing hole Ø 4,1 mm
4
Connection
5
LED indicator green: supply voltage
active
6
LED indicator yellow: status of
received light beam
7
BluePilot blue: alignment aid
20
M12
1
8
Ø
4
,1
3
9
,9
5
5
,4
5
5
,7
4
5
,5
5
7
42
29,9
52,9
6 17,5
3
6,5
15
28 7,5
35,5
4,1
4
3
1
6
2
5
7
20
M12
1
8
3
4
,5
1
6
Figure 2: Dimensional drawing 2, male con‐
nector
SAFETY INFORMATION
1
8020353 | SICK
Subject to change without notice
5