ELECTRICAL INSTALLATION
5
39
8021804/2017-11-27|SICK
Subject to change without notice
T R A N S L A T I O N O F T H E O R I G I N A L I N S T R U C T I O N S | Telematic Data Collector
5.2
Screwing on the GSM antenna
The GSM antenna is not installed at the factory. It needs to be screwed on before the
devices are commissioned.
Fig. 27: Screwing on the GSM antenna
1. Hold the device in place with one hand.
2. Place the GSM antenna on the antenna connector on the TDC device.
3. Screw the GSM antenna clockwise onto the antenna connector on the device.
5.3
Connecting the GPS antenna
The GPS antenna is usually installed in the driver's cab with clear visibility upward or in
the vehicle roof area.
Have an expert install the connecting cable in the vehicle depending on where exactly the
antenna is being installed and connect this to the TDC-B100/TDC-B200 device via the
Cinch male connector.
The TDC-M100 device cannot supply any GPS information, as there is no connector for
a GPS antenna.
Connecting the GPS antenna to the TDC-B100 /TDC-B200
Fig. 28: Connecting the GPS antenna to the TDC-B100 /TDC-B200
▸
Plug the Cinch male connector on the connecting cable for the TDC-B100/TDC-B200
device into the
GPS
female connector.
Note
