Figure 48: Terminals on the power supply plug
Table 7: Terminal assignment on the power supply plug
Terminal
Signal
Function
Wire color for pre-assembled
power supply plug with flying
leads
1
24 V DC
Supply voltage
1
2
–
Reserved
–
3
0 V DC
Supply voltage
2
6.2.2
Network connection using RJ-45 push-pull male connector
To connect the device to the network, you need to use push-pull male connectors with a
metal housing. With the push-pull plug connected, the connection complies with enclo‐
sure rating IP65 (e.g., Phoenix VS-PPC-C1-RJ45-MNNA-PG9-4Q5, part number:
1608100).
With the supplied cover, the connection complies with enclosure rating IP65.
If the network is not connected to a further network subscriber, then a connection using
a single male connector is sufficient. It does not matter which of the two female con‐
nectors is used. The unused female connector must always be protected with the sup‐
plied cover (
).
ELECTRICAL INSTALLATION
6
8013291/ZA19/2019-11-14 | SICK
O P E R A T I N G I N S T R U C T I O N S | S3000 PROFINET IO, S3000 PROFINET IO-OF
61
Subject to change without notice
