SICK PowerProx Mini WTT4SLC, Operating Instructions Manual

Page: 24 / 200

NOTE
Before calling, make a note of all type label data such as type code, serial number, etc.,
to ensure faster processing.
2 Safety information
2.1 General safety notes
Connection, mounting and configuration of the product must only be car‐
ried out by qualified personnel.
2006/42/EC
NO
SAFETY
This product does not constitute a safety component as defined in the
Machinery Directive.
Do not install the product in places exposed to direct UV radiation (sun‐
light) or other weather conditions.
The product must be adequately protected against moisture and contami‐
nation.
Laser notes
CAUTION
Interference, manipulation or incorrect use can lead to hazardous exposure due to laser
radiation.
The emitted light beam must not be focused by means of additional optical devices.
LASER
1
Figure 1: Laser class 1
This device complies with the following standards:
• EN/IEC 60825-1:2014
• 21 CFR 1040.10 and 1040.11 except for tolerances according to Laser Notice No.
56 dated May 8, 2019.
The laser is eye-safe.
The laser marking is located on the housing imprint on the sensor.
2.2 Intended use
The WTT4SLC is an opto-electronic photoelectric proximity sensor (referred to as “sen‐
sor” in the following) for the optical, non-contact detection of objects.
The system designer must provide measures to ensure the safety of persons and
systems in accordance with the legal guidelines.
SICK AG assumes no liability for losses or damage arising from the use of the product,
either directly or indirectly. This applies in particular to use of the product that does not
conform to its intended purpose and is not described in this documentation.
OPERATING INSTRUCTIONS
24 O P E R A T I N G I N S T R U C T I O N S | PowerProx Mini - WTT4SLC 8022570.1FBN/15.09.2022 | SICK
Subject to change without notice
en