38
8019897/V2-0/2017-12| SICK
O P E R A T I N G I N S T R U C T I O N S | PowerCEMS100
Subject to change without notice
7
OPERATION
7.5
Switching on
▸
Switch on the main switch on the system cabinet front door.
– Signal LED “POWER” lights red.
▸
Measuring screen appears on the display.
▸
Wait for the heating up phase to complete.
– Signal LED “POWER” lights red.
– The measured values blink on the display.
– Status bar shows “see logbook”.
During the heating up phase, the start process is saved in the logbook.
“Measure” is displayed in the status bar at the end of the heating up phase.
▸
Check safe operating state.
– Signal LED “POWER” lights red.
– Signal LED “FAILURE” does not light.
– Measuring screen active for constantly displayed measured values (not blinking).
Fig. 7: BCU operator panel, function buttons F1 - F4
7
Current menu branch
8
Current menu
9
Status bar
10
Menu number
Note
The display lighting switches off automatically after some time.
Reactivation:
Press the F1 or F4 function key.
Refer to the “Supplementary Operating Instructions BCU” for detailed informa-
tion on operating the BCU operator panel.