55
8018478/YWL5/2018-06| SICK
O P E R A T I N G I N S T R U C T I O N S | NAV245
Subject to change without notice
MOUNTING
5
5.3.4
Mounting with mounting kit 2 and 3
You can use mounting kits 2 and 3 (only in conjunction with mounting kit 1a or 1b) to align
the NAV245 in two planes. The maximum adjustment angle is ± 11° in both planes.
Fig. 48: Mounting with mounting kit 2 and 3
1
Mount mounting kit 1a or 1b on the NAV245.
2
Mount the mounting kit 3 on the mounting surface.
3
Insert the centering pin (4 mm) into the center hole of mounting kit 3.
4
Fit the mounting kit 2 onto mounting kit 3 and mount using two M4 × 10 fixing screws.
5
Then, mount the NAV245 on mounting kit 2 using the threaded holes in mounting kit 1a.
6
Adjust the NAV245 along the longitudinal and transversal axis and then tighten the six
fixing screws on the mounting kits.
Important
Please observe the dimensional drawings during mounting (see “Dimensional drawings” on
page 74).
5.4
Dismantling the NAV245
1
Switch off power supply.
2
Disconnect connection cables.
3
Unscrew the screws for mounting the NAV245 on the bracket and remove the device.
Important
On final decommissioning, please observe the requirements for environmentally correct
disposal in “Disposal after final decommissioning” on page 12.
Centering pin
Mounting kit 1a
Mounting kit 2
Mounting kit 3
M4 threaded holes
