SICK MCS200HW, Service Manual, Page: 98 / 146

98 8024638/AE00/V1-0/2019-09| SICK S E R V I C E M A N U A L | MCS200HW
Subject to change without notice
5
REPAIRS
5.3.4 Fitting the complete sender/receiver unit
1 Push sheet metal cover 1 in with foam insulation.
2 Insert the sleeves and tighten sheet metal cover 5.
3 Attach sheet metal covers 4 to 2.
4 Screw all sheet metal covers tight.
5 Fit the outer sheet ( see Fig. 140 “Sender/receiver unit, outer plate”, page 96 ):
▸
Guide the power supply cable through the recess.
▸
Tilt the sheet slightly when attaching.
6 Connect the hose connections of the sender/receiver unit to the outer sheet.
7 Attach the inner bracket and screw tight ( see Fig. 138 “Transmit/receive unit, front
side”, page 95 ).
8 Screw the templates tight on the rear side ( see Fig. 137 “Sender/receiver unit, rear
side”, page 95 ).
9 Hook the sender/receiver unit with the mushroom head brackets into the device
cabinet.
10 Screw the sender/receiver unit tight on the device cabinet ( see Fig. 136 “Sender/
receiver unit, fastening screws”, page 94 ).
11 Connect the plug connections.
12 Screw the electronics housing cover tight.
13 Replace the drying agent ( see Chapter “Replacing the drying agent”, page 44 ).
14 Close the cover of the sender/receiver unit (optional) and screw tight.
5.3.5 Replacing the fan
1 Disconnect the MCS200HW power supply.
2 Remove the electronics housing cover and fan cover ( see Chapter “Removing the elec-
tronics housing cover”, page 88 ).
3 Disconnect the fan power supply.
Tools required
Phillips screwdriver
6 mm Allen key
2.5 mm Allen key
Tweezers
Tools required
Phillips screwdriver
Spare parts set No. Contents
2099749 Fan with filter unit for electronics unit