7
OPERATION
8020065-ZSP4/2017-08-10|SICK
O P E R A T I N G I N S T R U C T I O N S | Master Data Analyzer
Subject to change without notice
88
7.6
Repeating incorrect measurements
If a measurement has not been completed successfully, a message will appear on the
SIU display, describing the error and providing information on the troubleshooting process.
In this case, you must rectify the problem and perform the measurement again. The
following examples show the points to note when repeating measurements.
7.6.1
Object was positioned incorrectly
If the entire object was not placed in the measurement field, you will receive the following
error message upon completion of the volume measurement.
▸
Press
OK
to confirm you have seen the error message. The window containing the
message closes.
If you accidentally close the window without having read the error message, you can
display the notes again. To do this, click on the red symbol for measurement status in
the list of status indicators.
Repeat measurement in the operating mode with bar code scanning
In the operating mode with bar code scanning, the bar code must be scanned again
before the measurement can be repeated. This creates a new measurement data set.
1. Position the entire object in the measurement field.
2. Record the bar code with hand-held scanner or enter it manually.
3. Move the measurement gantry over the object.
Once the volume has been measured, all measured values appear on the display and
are transmitted by the MSC800 controller to the customer system via the defined
interface.
Note
