Online help
LMS400
Configuration
8011984/YSZ3/2016-02-04
© SICK AG · Germany · All rights reserved · Subject to change without notice
9
Chapter
3
see section
3.6.4 “Filter for the Level Control application” on page 18
see section
3.7.7 “Internal gate” on page 22
How to select the Level Control application:
3.3
Position
Note
The P
OSITION
device page is only displayed if you have activated the Level Control application
(see
).
On this device page you can enter the coordinates and angle of the LMS400 over the
conveyor system and in this way define the zero point for the system.
You can also define the relevant working area as the measurement area.
3.3.1
Coordinates
As delivered the zero point for the distance measurement is at the origin of the laser
(marked by a dot on the top and underside of the housing).
The Level Control application requires a global zero point to which all other settings refer
(e.g. right edge of the conveyor system as seen in the transporting direction). You can define
this zero point with the aid of the X, Y and Z coordinates.
As a rule this zero point is at the bottom right edge of the conveyor system as seen in the
transporting direction.
Fig. 1:
LMS400
coordinates above a conveyor system
X coordinate
Enter the value 0 mm in the field.
Open in the P
ROJECT
TREE
, LMS400-XX00, P
ARAMETER
the device page A
PPLICATION
.
In the A
PPLICATION
field select the option L
EVEL
C
ONTROL
.
The additional device pages for the application are displayed in the project tree.
LMS400
y
z
