Chapter
6
Operating Instructions
TPS
44
Operating Instructions | SICK
8021799/2017-09-26
Subject to change without notice
Commissioning
Saving settings
Click on the
done
icon. The settings are permanently saved in the system.
You will then be taken back to the overview page with the individual setup steps.
The setup step
Vehicle setup
now has a green check mark.
6.4
Configuring the LiDAR sensors
6.4.1
Starting sensor setup
When setting up the parameters for the LiDAR sensors, an assistant provides support for
all LiDAR sensors.
Click on the
Sensor setup
icon.
Sensor setup is done in a separate screen, showing all available sensors, a green check
mark or red not ok mark indicator is shown at each of them.
After the successful completion of any sensor setup, the indicator that was initially a red
not ok mark will turn to a green check mark.
The result of the sensor setup, displayed in the main setup page, will not turn to a green
check mark until all of the individual sensors have been successfully configured.
Navigation
As soon as the entries have been completed on one assistant page, use the
next
icon to
navigate to the following page.
When changing the assistant page, the settings and information that have been provided
are temporarily saved.
Note
