1.
Press and hold the Mode button for 2 s.
2.
Use the plus or minus button to select Pro.
OUT
3.
Press the Mode button.
4.
Use the plus or minus button to select AdC.
OUT
5.
Press the Mode button. The preset value flashes.
OUT
6.
Use the plus or minus button to select on or oFF.
OUT
Deactivated (factory setting)
OUT
Active
7.
Press the Mode button.
7.6.11
Setting receiver amplification
The factory setting for receiver amplification is “Auto”. In this operating mode, the sen‐
sor selects a suitable amplification during the teach-in process based on the measured
signal. For special applications (e.g. with high contrast fluctuations), it may make sense
to define the amplification manually.
1.
Press and hold the Mode button for 2 s. The Configuration operating mode is
active.
2.
Use the plus or minus button to select Pro.
OUT
3.
Press the Mode button.
4.
Use the plus or minus button to select GAin.
OUT
5.
Press the Mode button. The preset value flashes.
OUT
6.
Use the plus or minus button to select the desired setting.
OUT
Automated (factory setting)
OUT
High
OPERATION
7
8023304.11XV/2018-11-29 | SICK
O P E R A T I N G I N S T R U C T I O N S | KTL180
35
Subject to change without notice
