5
COMMISSIONING AND OPERATION
30
Operating Instructions | InspectorP Rack Fine Positioning
8024534 / / 2019-08-19
Bit position Meaning
D0 (LSB)
Circle has been found, measured values are valid.
D1
Continuous measurement is switched on.
D2
1: Double deep is activated.
0: Single deep is activated.
D3
Saving the images on a microSD memory card is activated.
D4
Not allocated.
D5
Command 4: “Parameterization of diameter and distance” is currently
being processed. The bit is deleted after successful implementation.
D6
Command 5: “Parameterization of evaluation with target region for single
deep” is currently being processed. The bit is deleted after successful im-
plementation.
D7 (MSB)
Command 6: “Parameterization of evaluation with target region for dou-
ble deep” is currently being processed. The bit is deleted after successful
implementation.
5.4.5
Control via digital inputs and digital outputs
Digital input sensor 1 activates and deactivates continuous measurement. The sensor
2 digital input can be used to switch between the Single and Double deep modes.
Sensor 1
1
Continuous measurement is switched on.
0
Continuous measurement is switched off.
Sensor 2
1
Double deep mode is activated.
0
Single deep mode is activated.
The IN/OUT 3 – IN/OUT 6 digital outputs give information about the current position of
the positioning mark.
IN/OUT 3
(up)
IN/OUT 4
(down)
IN/OUT 5
(right)
IN/OUT 6
(left)
Position of the positioning mark relative to
the target region
1
1
1
1
The positioning mark is located within the
target region.
0
1
1
1
The positioning mark is located above the
target region (Y+).
1
0
1
1
The positioning mark is located under the
target region (Y-).
1
1
0
1
The positioning mark is located to the right
of the target region (X+).
1
1
1
0
The positioning mark is located to the left of
the target region (X-).
0
1
0
1
The positioning mark is located to the right
above the target region (Y+/X+).
0
1
1
0
The positioning mark is located to the left
above the target region (Y+/X-).
1
0
0
1
The positioning mark is located to the right
under the target region (Y-/X+).
