6
COMMISSIONING AND CONFIGURATION
78
8011325/18IM/2020-07-02|SICK
O P E R A T I N G I N S T R U C T I O N S | ICR880/890
Subject to change without notice
6.3.4
Restarting the camera system
Once you have configured all parameters, we recommend restarting the camera system.
This means you can be sure that all parameters are active.
1. Disconnect the controller unit's power supply unit from the voltage supply.
2. Reconnect the voltage supply. The camera system starts.
6.4
Restoring the default
The values of the default are permanently saved both in the camera system and in the
database of the SOPAS-ET configuration software and can be restored at any time. This
means that you can discard all changes in the parameter set again.
The SOPAS-ET configuration software is connected to the camera system online.
1. In the menu bar under
ICR8xx
, select the
Parameter
Load factory default
command.
2. Press
Yes
to confirm the prompt.
Requirements
