SAFETY
2
15
8011325/18IM/2020-07-02|SICK
Subject to change without notice
O P E R A T I N G I N S T R U C T I O N S | ICR880/890
2.3.3
Potential sources of danger
The camera system has been designed such that it can be operated safely. Protective
devices reduce potential risks to the maximum possible extent. However, a certain level of
risk will always remain.
Awareness of potential sources of danger caused by the device will help you to work in a
safer manner and therefore prevent accidents.
That is why all persons involved with the transport and storage, mounting, commissioning
and decommissioning, operation, and maintenance and repair must carefully read and
observe the following safety notes.
In order to avoid danger, also follow the special warning information in the individual
chapters as well as the current national accident prevention regulations, and any
company work, operation, and safety regulations.
Danger due to electrical current
HAZARD
Risk of injury due to electrical current
The cabinet of the controller unit is connected to the power supply
(AC 100 V ... 264 V/50 Hz ... 60 Hz).
Measures
▸
Current safety regulations must be observed when working on electrical devices.
▸
The power supply must be disconnected when attaching and detaching electrical
connections.
▸
Select and implement wire cross-sections and their correct fuse protection at the
beginning of the wire seen from the source of electricity in accordance with the
applicable standards.
HAZARD
Risk of injury due to improper handling of live components
Improper handling of live devices may lead to severe personal injury or death by electric
shock.
Measures
▸
Electrical installation and maintenance work must always be carried out by personnel
authorized to do so.
▸
Do not touch any live parts.
▸
In the event of danger, immediately disconnect the system from the power supply.
▸
Always use original fuses with the specified current rating.
▸
All control cabinets must be securely closed during operation.
▸
Before opening the cabinet, disconnect the entire system from the power supply and
secure it against being switched on again.
▸
Report any damaged cables to the maintenance team without delay.
