5
Mounting
5.1
Information on installation in potentially explosive atmospheres
DANGER
Risk of explosion through incorrect installation
Incorrect assessment of the installation location as well as all further installation work
in potentially explosive atmospheres can cause serious injuries to people and damage
during operation.
•
Installation, start-up, maintenance and inspection should only be performed by
technicians having knowledge of the relevant rules and regulations for potentially
explosive atmospheres, especially:
–
Ignition protection types
–
Installation regulations
–
Zone classification
•
Standards to be applied:
–
IEC 60079-14, Annex F: Knowledge, skills and competencies of responsible
persons, operatives and designers
–
IEC 60079-17: Electrical installations inspection and maintenance
–
IEC 60079-19: Equipment repair, overhaul and reclamation
5.1.1
Safety of measuring probes suitable for Ex zones
DANGER
Risk of explosion with a measuring probe not suitable for Ex zones
Measuring probes containing electronics, temperature or pressure sensors, are not
approved for operation in potentially explosive atmospheres and could cause an explo‐
sion.
b
Only use the explosion-proof SICK GMP measuring probe.
5.2
Tools required
Tools
Part No.
Required for
Adjustment device
2034121
Alignment of "flanges with tube"
19 mm jaw wrench
Flange screw fitting
Screwdriver
Connections
Allen key
Connections
5.3
Material required
Material
Required for
Personal protective equipment
Protection when working at the sampling point
Pipes for protective gas
Protective gas feed line,
see "Connecting protective gas to the
.
5
MOUNTING
28
O P E R A T I N G I N S T R U C T I O N S | GM32-Ex
8015558/YYJ8/V1.7/2016-07 | SICK
Subject to change without notice
