SICK deTem4 LT Muting A/P, Operating Instructions Manual, Page: 48 / 108

8. Now connect the connecting cables to the muting signal A and muting signal B
connections of the active unit.
(
5.4 Mounting
Important information
NOTE
b
Read this section in full before mounting the brackets.
b
Read information about aligning the active and passive units, see "Alignment of
the active and passive units", page 65
DANGER
Hazard due to lack of effectiveness of the protective device
Persons or parts of the body to be protected may not be recognized or not recognized in
time in case of non-observance.
b
Take account of the minimum distances calculated for the machine: see "Mini‐
mum distance from the hazardous point", page 19 , see "Minimum distance from
reflective surfaces", page 21 .
b
Mount the protective device such that nobody can pass under the lowest light
beam, pass over the highest light beam, get between two light beams, or pass by
the side of the protective device.
Notes on mounting
b
Mount the active and passive units on a level surface (
!
).
5
MOUNTING
48 O P E R A T I N G I N S T R U C T I O N S | deTem4 LT Muting A/P 8024802/2020-07-17 | SICK
Subject to change without notice