SICK deTem4 Core Ex, Operating Instructions Manual

Page: 33 / 68

Further topics
• "Brackets", page 58
5.3.2.1 Mounting the FlexFix bracket on a machine or profile frame
Mounting method
Table 4: Lateral and rear mounting with the FlexFix bracket
Mounting
method Description
On the side With the M5 screw through the FlexFix bracket on the machine or profile
frame. A screw nut or threaded hole is required on the machine or profile
frame (
!
).
With the M5 screw through the FlexFix bracket on the profile frame. 2 sliding
nuts are required on the profile frame (
"
).
On the back With the M5 screw through the FlexFix bracket on the machine or profile
frame. A screw nut or threaded hole is required on the machine or profile
frame (
§
).
!
"
§
Figure 17: Mount FlexFix bracket to a profile frame
1
Mounting on the side
2
Mounting on the side
3
Mounting on the back
Approach
1. After assembling the FlexFix brackets, screw the sender or receiver into the FlexFix
brackets from the front. (
!
)
2.
Align the sender and receiver. (
"
)
3. Use an M5 screw to secure the position of the sender and receiver in the FlexFix
bracket. (
§
)
MOUNTING
5
8020453/14Q7/2020-04-27 | SICK O P E R A T I N G I N S T R U C T I O N S | deTem4 Core 33
Subject to change without notice