NOTICE
If the ambient temperature is below 0 °C, please note:
•
The black rubber cover fitted at the side over the corner must be flush with the
device.
•
Do not
move the swivel connector on the device.
5.2.3
Mounting device
The device is mounted to the bracket via at least two M5 tapped blind holes. The blind
tapped holes are located in pairs on both of the narrow sides of the device,
.
SICK brackets
The device can be installed using optional SICK brackets or customer-specific brackets.
SICK offers prefabricated brackets which are optimally suited for the mounting of the
device in a wide range of applications. See:
•
Figure 9: Mounting example of a device with bow-shaped mounting bracket. Illustration may
differ from actual device.
Devices with heating
NOTE
In devices with heating, use special mounting brackets for thermal decoupling.
Suitable mounting brackets are available as accessories (part no. 2050705 and
2058082). Use the plastic insulating washers for thermal insulation of the device
against the bracket. These insulating washers are included with the mounting brackets
for thermal decoupling.
You will find corresponding mounting brackets under:
•
MOUNTING
5
8017842/19XD/2021-11-19 | SICK
O P E R A T I N G I N S T R U C T I O N S | CLV61x DualPort (PROFINET)
31
Subject to change without notice