O P E R AT I N G I N S T R U C T I O N S | Bulkscan®
8014829/ZV98/2018-05-07| S I C K
Subject to change without notice
3 9
MOUNTING
5.3.7
Direct mounting of Bulkscan® LMS111
The Bulkscan® LMS111 has two M5 × 8 threaded holes on the rear. Using them you
can mount the Bulkscan® LMS111 directly on the intended mounting surface. To avoid
a possible tendency to vibrate, the reference surface on the rear can be used as the
third mounting point (1).
M5x8
Fig. 19: Direct mounting
During mounting, observe the dimensional drawings (see "11.4.5 Dimensional drawing
Bulkscan® LMS111“ on page 91).
5.3.8
Mounting of Bulkscan® LMS111 with mounting kit 1a or 1b
Using mounting kit 1 you can mount the Bulkscan® LMS111 on a mounting surface
(wall, machine). The mounting kit is available as mounting kit 1a without protection
device for the optics cover and as mounting kit 1b with protection device for the optics
cover.
Note
