8
FLOWSIC100 Flare · Addendum to Operating Instructions · 8025365/V1-0/2020-05 · © SICK Engineering GmbH
About this document
1.1
Function of this document
This document supplements the FLOWSIC100 Flare Operating Instructions and is to be
used only in combination with the Operating Instructions. The Addendum describes the
FLSE-XT sender/receiver units for connection to the MCUP.
The content of the FLOWSIC100 Flare Operating Instructions applies as long as not
described differently in this Addendum.
1.2
Scope of application
● This document supplements the following Operating Instructions:
– FLOWSIC100 Flare (Part No. 8013344)
● The document is not applicable to other SICK measuring devices.
1.3
Target groups
This Manual is intended for persons installing, operating and maintaining the device.
Operation
The device may only be operated by authorized persons who, based on their training on,
and knowledge of the specific device, as well as knowledge of the relevant regulations can
assess the tasks given and recognize the hazards involved.
Installing and maintaining
Skilled persons are required for installation and maintenance, see
.
1.4
Data integrity
SICK Engineering GmbH uses standardized data interfaces such as standard IP technology,
in its products. The focus here is on the availability of the products and their properties.
SICK Engineering GmbH always assumes that the customer is responsible for the integrity
and confidentiality of data and rights involved in connection with using the products.
In all cases, the customer is responsible for the implementation of safety measures
suitable for the respective situation, e.g., network separation, firewalls, virus protection and
patch management.
1.5
Further information
NOTICE:
Observe all supplied documents.
