8017035/ZMO9/2017-06-08 • © SICK AG • Subject to change without notice.
53
PRO2-Navigator Setup Software
6.3.3
Common Setup
This section explains the details of the common setup screen.
1
6
8
7
ß
9
2
5
Number Display item Description
Operation
1
Port
Set the port to use for communica-
tion between the sensor head and
the computer.
Select from the list the port to use for communication.
The ports that are currently connected to the computer are
displayed automatically.
2
Baudrate
Set the communication baud rate.
Select from “9600bps,” “19.2kbps,” “38.4kbps,”
“57.6kbps,” “115kbps,” “230kbps,” “460kbps,”
“921kbps,” “2Mbps,” and “4Mbps.”
(The default value of the sensor is “2Mbps.”)
3
Bank Switch
Select how to switch between banks. Select the bank switch method from "Body" and "Comm." If
you use “PRO2-Navigator.” to switch the bank, this setting
will automatically be changed to "Comm."
4
On Timing
Set the output behavior.
Select the output ON/OFF behavior for “Out Range” or “In
Range”. Detailed explanations are at
]
.
5
Axis Dir
Set the direction in z-axis to increase
and decrease the height direction
value.
Set which side's values to use as positive with the
measurement center used as the center.
6
Unit
Set the measured result display unit. Select the display unit from “mm” and “μm.”
7
Resolution
Set the number of digits of the
measured result to display.
Select from “1mm,” “0.1mm,” “0.01mm,” and “0.001mm.”
8
Language
Set the display language of
“PRO2-Navigator.”
Select the display language of “PRO2-Navigator.”
You can select from “en” (English), "cn" (Chinese Simpli-
fied), "ko" (Korean) and “ja” (Japanese).
(Even if you change this setting, the sensor display
will not be changed.)
3
4
